#Energy
No kWh Meter? Estimate Daily Electricity Costs from Current
Notes on converting CT current readings into energy usage and daily time-of-use electricity costs, from the three-phase power formula and the sampling interval built into it, through skipping outages and separating peak from off-peak with epoch arithmetic, to a daily summary table that made the web page seven times faster.
Shared Neutrals Across Transformers: Why Phase Balancing Is Not Enough
A case involving two transformers with interconnected neutrals and houses tapped into one side's main feeder, leaving phase A 30-40 A higher even on days off, plus a meter-reading trap that can suggest a 200 A difference if the CT ratio is not verified first, and a repair sequence that must be followed in order.
Diagnosing Feeder Overload from Melted Insulation and Duty Cycles
My investigation of a 95 mm² main cable with insulation melting at scattered points even though the system seemed to work normally, from the nameplates of 6 washers and dryers totaling 234.7 kW to a minute-by-minute current model explaining why a 482 A load on a cable rated for 180 A had not caused a visible system failure.
Reading a DTSU666 3-Phase Meter with Raspberry Pi over Modbus RS485
Notes on connecting a DTSU666 Smart Power Sensor to a Raspberry Pi over RS485, reading 3-phase electrical measurements from multiple meters using Modbus RTU, decoding 32-bit floats correctly, and storing them in SQLite/MySQL before exporting through MQTT and a REST API, including a negative-value bug I ran into myself